Hello Blasters,
As the subject says...
New cuts in cuts.C file. TDC cuts for Hydrogen elastic event timing cuts are:
Inbending:
------------
ep_in_TDC_pL
ep_in_TDC_pR
These peaks go from {electrons:TOF 0 :: Protons:TOF 15} up to {electrons:TOF 15
:: protons:TOF 5}
Outbending:
------------
ep_out_TDC_pL
ep_out_TDC_pR
Outbending has no electrons in TOF 0-2 or 15. Protons are landing from TOF 5
through 15.
NOTE: Use these one at a time, preferably with no other cuts because root will
tell you that your string is too long. I suggest another similar elas_flrn.C...
I'll start it tomorrow and write a new filter file with these inside as well as
the ADC cuts...
ADC Cuts for H elastic events:
Inbending:
-------------
ep_in_ADC_pL
ep_in_ADC_pR
Outbending:
-------------
ep_out_ADC_pL
ep_out_ADC_pR
These strings are nowhere near the length of the timing cuts.
Therefore, you can add cuts to these cuts... Should not be a problem. Again,
I'll have a new elas_flrn.C in a day or so...
hasta luego,
eugene
--------------------------------------------------------------------------
Eugene Geis
PhD Student, Physics Department, ASU
Research Affiliate, MIT-Bates Laboratory of Nuclear Science
eugene.geis@asu.edu
--------------------------------------------------------------------------
"Question all you think you know; you may find some answers."
--------------------------------------------------------------------------
** Check Out the Phatty Acidz @ www.phattyacidz.com **
This archive was generated by hypermail 2.1.2 : Mon Feb 24 2014 - 14:07:30 EST